WARNING
You must use the proper length front grip frame screw with your new body.
10-32 x .625 (5/8”) Button head
If the screw is to long it will act as a stop and when you fire the marker the bolt will destroy the detent.
A new front grip frame screw is provided with your new body.
I suggest you get in the habit of verifying the screw length whenever you disassemble the marker.
You can check the length by sticking an allen key into the feedneck and pressing on the detent.
If the screw is to long the detent wont drop below the bottom of the feed breach.
10-32 x .625 (5/8”) Button head
If the screw is to long it will act as a stop and when you fire the marker the bolt will destroy the detent.
A new front grip frame screw is provided with your new body.
I suggest you get in the habit of verifying the screw length whenever you disassemble the marker.
You can check the length by sticking an allen key into the feedneck and pressing on the detent.
If the screw is to long the detent wont drop below the bottom of the feed breach.
Body Assembly Notes
Luke's Customs Marker Assembly Notes.
Your marker was loosely assembled for shipping purposes only, it is NOT ready to use, no thread sealer was used on your LPR-FG. I figured it would be more confusing to ship everything in bags, this way you can get a quick lesson on all the parts and pieces and how they go together.
I suggest you bag and tag the parts as they are removed to aid in the reassembly after anodizing. I do have color photos on my website, the address's are on your parts diagrams included with your marker.
If you have any questions, please PM me on AO and I'll help with any issues you may encounter.
A few notes:
I hope you enjoy your new marker.
Thank you for supporting Luke's Customs
Your marker was loosely assembled for shipping purposes only, it is NOT ready to use, no thread sealer was used on your LPR-FG. I figured it would be more confusing to ship everything in bags, this way you can get a quick lesson on all the parts and pieces and how they go together.
I suggest you bag and tag the parts as they are removed to aid in the reassembly after anodizing. I do have color photos on my website, the address's are on your parts diagrams included with your marker.
If you have any questions, please PM me on AO and I'll help with any issues you may encounter.
A few notes:
- There are additional parts under the right hand grip panel.
- Don't forget there is a magnet in the top of your trigger. To remove it just touch an allen key or anything metal to the end and it will slide out.
- The top two magnets and plastic spacer for the trigger return can be assembled in several configurations to adjust your preferred trigger return feel.
- Be careful removing the Carrier assembly, it will bend if you get to rough with it. You can use an 1/8” allen key to gently pry the carrier out of the body by inserting the angled end under the Carrier beside the thumb screw and gently prying it loose.
- Don't forget you still need to use your factory thumb screw and rail bushing.
- Installing the stainless steel spring cup can be a little tricky, I found the placing the cup on the AGD valve assembly (spring) and turning the marker on it's side, then installing the valve works the easiest. Just make sure the cup is fully seated once assembled.
- Be certain every time you assemble your marker that you're using the correct front grip screw, if it's too long you will destroy your detent. Verify the detent operates properly with an allen key through your feedneck. The correct screw size is 10-32 x .625 (5/8”) button-head.
I hope you enjoy your new marker.
Thank you for supporting Luke's Customs